JIG construction progress (small)
Had an hour spare this morning and made some progress with the JIG.
Standard fence top has been swapped out for this new unpainted base plate that will hold a linear rail and two bearing blocks for guiding the Right-angle JIG.
http://www.brisdance.com/Wood/RT/New...gJig/RAJ01.JPG . http://www.brisdance.com/Wood/RT/New...gJig/RAJ02.JPG
A length of rectangle aluminium box section is fitted between the two bearing blocks ready to be attached to a right angle fitting (to be made) that will glide across the table at 90 deg to the fence and move/track with the fence.
http://www.brisdance.com/Wood/RT/New...gJig/RAJ03.JPG . http://www.brisdance.com/Wood/RT/New...gJig/RAJ04.JPG
The JIG face can be moved back to the edge of the table if needed, the face can travel far enough across the table to allow the workpiece to move past the largest router bit that would fit in the table.
http://www.brisdance.com/Wood/RT/New...gJig/RAJ05.JPG . http://www.brisdance.com/Wood/RT/New...gJig/RAJ06.JPG