27th Jul 2019, 11:04 PM #1
DIY Router Table finally complete (sort of..)
Finally got around to completing the dust extraction and mitre track for front featherboard today. With these complete Im more or less calling this project complete.
I started this table back in January 2018 with an $89 Bunnings work bench and the Ryobi router. At that stage I had no intention to, or even knew about, adding a fence, featherboards, router plate inserts etc.
My initial purpose for the table was for making HDPE speaker adapters for a car stereo install using a flush trim bit. Since then I have rediscovered woodworking and have been putting this table together over the past 6 or so weekends. Just doing a little at a time and screwing and re-doing things.
In any event, it's been fun and Im now looking to build some shed cabinets.
IMG_20190727_133008.jpg IMG_20190727_133018.jpg IMG_20190727_133036.jpg IMG_20190727_133153.jpg
27th Jul 2019 11:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Advertising world
28th Jul 2019, 08:04 PM #2
looking very good. simple and practical, what size hose for your dust and being sucked into what?
ps is the car in background the one speakers were for? what brand of car?Life expectancy would grow by leaps and bounds if green vegetables smelled as good as bacon.
28th Jul 2019, 09:51 PM #3
2x 2.5" hoses that are currently attached to a Ryobi wet/dry with DIY cyclone. It get's the job done for the time being but I plan on getting a 2hp dust extractor.
Yes, that's the car. I did a complete custom stereo install. My first go at that as well. Pics below is version 1 of the table and the cyclone that works reasonably well. Photos of front door install from before and after. Car is a Renault Megane RS265.
IMG_20180422_160249 (4).jpg IMG_20171226_141210.jpg IMG_20180325_154233 (1).jpg IMG_20180327_191610 (1).jpg IMG_20180512_125149 (1).jpg
28th Jul 2019, 09:54 PM #4Senior Member
- Join Date
- Dec 2017
- Aldinga Beach
By Old_Tom in forum ROUTING FORUMReplies: 2Last Post: 20th Jul 2019, 04:29 PM
By syksie in forum WOODWORK - Tools & MachineryReplies: 3Last Post: 21st Aug 2018, 11:04 PM
By Inzy1 in forum ROUTING FORUMReplies: 29Last Post: 30th Jul 2015, 01:44 PM
By Inzy1 in forum HAND TOOLS - POWEREDReplies: 1Last Post: 13th Jul 2015, 06:48 PM
By stephen brill in forum TRITON / GMCReplies: 2Last Post: 25th May 2004, 03:42 PM