Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Mitre Track fitting into table
-
28th December 2009, 04:28 PM #1
Mitre Track fitting into table
I have just cut a slot in the top for a Mitre Track.Do you guys epoxy these in or just use screws.
I have a .25 mm gap down the length of the track so I was thinking the epoxy might seal this off .
Thanks Greg
-
28th December 2009 04:28 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
3rd January 2010, 09:24 AM #2
I would just use screws. Epoxy is a bit too permanent. When you build the next version router table you may want to move it.
I wouldn't worry about that gap.
Similar Threads
-
Mitre track
By damian in forum ROUTING FORUMReplies: 6Last Post: 3rd June 2008, 10:23 AM -
Mitre track in router table
By masher in forum ROUTING FORUMReplies: 11Last Post: 14th September 2007, 12:14 AM -
Mitre Track or not????
By Gwhat in forum ROUTING FORUMReplies: 15Last Post: 12th April 2005, 11:34 PM -
Mitre track now available
By Gwhat in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 13Last Post: 12th January 2005, 10:28 AM