Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
26th June 2013, 06:52 PM #1New Member
- Join Date
- Jan 2012
- Location
- Katoomba NSW
- Posts
- 4
6''pvc to two or three 4'' outlets
I am looking at running 6'' pvc to 3 4'' outlets after a clearvue 6'' blastgate. Any advice on the best and most cost effective method of doing this would be very much appreciated. Please keep in mind I have no experience in playing with pvc to date. Clearvue have 6'' to two 4'' outlets but I have it on good advice that I will require three 4'' outlets to obtain adequate fine dust removal. ( thanks Bob L)
Thanks
Neil
-
26th June 2013 06:52 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
26th June 2013, 07:58 PM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,794
One way is to use 2 x 6" Storm water WYE junctions like
dwv-17_m.jpg
Then you need to add 6 to 4"" level invert junctions" like this to the 3 remaining 6" openings
level_invert_m.jpg
But if you can get these they cost a little more but you save on the cost of 2 level inverts.
junction_plain_ff_reducing_m.jpg
-
26th June 2013, 08:40 PM #3New Member
- Join Date
- Jan 2012
- Location
- Katoomba NSW
- Posts
- 4
Thanks again Bob, makes sense once I see it. I'm going to change my machine ports to 6'' where I can but some like the carbatec drum sander may prove difficult. This has a 2.5 '' port which I think I may be able to upgrade to 4'' only.
Neil
Similar Threads
-
buying first mig - have 20 amp fuse but 10 amp plug outlets in shed..
By woodmama in forum WELDINGReplies: 86Last Post: 27th April 2009, 02:48 PM -
15 Amp Tablesaw but only 10 amp outlets
By Dean in forum WOODWORK - GENERALReplies: 49Last Post: 6th May 2008, 09:36 PM -
outlets
By weisyboy in forum WOODWORK - GENERALReplies: 2Last Post: 12th August 2007, 09:55 PM -
timber outlets in brissie?
By bails in forum WOODWORK - GENERALReplies: 11Last Post: 29th September 2005, 12:35 AM