Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
6th September 2020, 11:56 AM #1
Cyclone silencer. Feedback wanted.
I’ve finally got a silencer roughed out.
Made from what I had lying around.
As shown in the photo it’s formply with internal dimensions of 360 x 360 x 1200.
With a 100 centre layer of 50mm batts and a 50 layer down each side.
Held in with 25mm stainless mesh. Shaped lead in and out ends in sheetmetal.
The outlet from the blower is 150 round transitioning to the 360 square using some bent ply and straight sides contained in formply for strength and sound deadening.
Same for the exit thru the wall which will be about 180 x 250 rectangular.
This will be inside next to the cyclone unit the inlet and exit connections will be about 60 degree bends.
I will be able to put another layer of formply over this if needed as it’s in a 1m space between the cyclone and the rear shed wall, backed by a double brick wall to the main part of the shop.
Any thoughts before I manhandle this monster into place.
It will be supported by the bottom transition exit bend out the shed wall which will be a form ply box shaped internally with bent ply etc.
H.F25D65F1-80CB-4C32-9A23-1EADF2A81BDA.jpeg4D9CCC4B-6481-4F5B-8E54-9C0CA93510D3.jpegJimcracks for the rich and/or wealthy. (aka GKB '88)
-
6th September 2020 11:56 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Laguna 14-BX feedback wanted.
By MandJ in forum BANDSAWSReplies: 30Last Post: 21st December 2016, 03:10 PM -
Air Tool Silencer
By Blu_Rock in forum METALWORK FORUMReplies: 9Last Post: 4th September 2012, 08:27 PM -
Carba-tec sbw 4300CE feedback wanted
By skippy in forum BANDSAWSReplies: 2Last Post: 16th December 2010, 02:42 AM -
Feedback wanted - Yr 9 Students working at Sydney Timber Show
By eddie the eagle in forum WOODWORK - GENERALReplies: 3Last Post: 27th June 2009, 10:44 AM -
mk3 silencer
By Gags_17 in forum TRITON / GMCReplies: 3Last Post: 18th October 2007, 11:02 AM