Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Motor mounting for cyclone
-
14th November 2004, 09:39 AM #1New Member
- Join Date
- Mar 2004
- Location
- West Pennant Hills
- Posts
- 2
Motor mounting for cyclone
I'm in the process of building a cyclone for my shop. I've got a Jet DC1900 blower and motor which comes with the motor mounts etc. All the research I have done shows the motor and blower attached directly to the top of the cylone, with the motor in a vertical position. I am thinking of mounting the motor and blower in a horizontal position above the filter stack, with a 9" ninety degree bend out of the top of the cyclone into the blower, with the blower blowing straight down into the filters. I can't see why this configuration should be any worse than the vertical one ( provides some benefits for installation and disassembly), but does anyone have any thoughts, or other information?
-
14th November 2004 09:39 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
14th November 2004, 09:24 PM #2
From experience I can say that it won't make too much difference in performance and I think that it would be easier to make and service.
Have a nice day - Cheers
-
19th November 2004, 05:55 PM #3Senior Member
- Join Date
- Apr 2003
- Location
- Adelaide, SA
- Age
- 88
- Posts
- 239
Phillip - I've been away and therefore a bit slow to respond.
Have a look at my web site (address below) and you will see what I have done. My blower and motor (3 ph 3 HP) is at floor level. I have a 'u' bend at the top and a 6" pipe down to the blower. I simply couldn't find (a) the space and (b) the strength to put the motor on the top!
What your proposing should be no problem at all.
CheersGeoffS
-
20th November 2004, 04:08 PM #4New Member
- Join Date
- Mar 2004
- Location
- West Pennant Hills
- Posts
- 2
Thanks for the input guys. I must admit, the weight is a bit daunting. I'm planning on mounting the motor and blower on top of a ~4ft by 2ft platform and hopefully lifting that up to the ceiling with block and tackle, then mounting the cyclone and filter stack to the underside of the platform, with the whole lot suspended on anti-vibration mountings from the rafters. Mounting it on the floor crossed my mind as well (even under the floor), so I guess I'll get it up and see how it goes.
Geoff, like your bench. It's very similar to mine. I put an extra row of dog holes down the length of the bench in front of the tool tray, which is usefull. The only thing I would have done different on mine would have been to put twin screws on the front vyce...I'll probably get around to that one day.
Sorry about the slow responses...computeers been off line for a week. Hopefully the dust extractor will be more reliable!
Phillip