Thanks: 0
Needs Pictures: 0
Results 1 to 3 of 3
-
10th November 2022, 11:41 AM #1
Repurposing hi bay shades as lathe hoods
Tried to sell these, no takers so decided to use them to suck the fine dust when sanding on the lathe.
I had thoughts of turning up a segmented ring and bashing it into that but thought I just try a bit of pipe first and some soft hammers.
Made some progress so put it in the Ewheel.
I’ve put some photos below whose order etc is out of my control😳
I can’t get at my smaller rad bottom wheels atm ‘cause of ply etc leaning on their cabinet but this one has started to form the desired edge rad ok.E6BD0E45-6AD4-4CE5-9B4E-FE04BFB11344.jpg687CB31D-80D8-4C2A-AE6E-A95072B3C5A5.jpg4DED879D-1D55-4B10-AAD3-A074F51060D3.jpg811C68A8-012F-4A9F-A33B-B0331A621284.jpg002D9EC5-D191-4E87-91B1-36B0E56705A5.jpg7B195B8D-0A00-422B-9038-2DB522DAD1D7.jpg
H.Jimcracks for the rich and/or wealthy. (aka GKB '88)
-
10th November 2022 11:41 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th November 2022, 11:30 AM #2
Here it is ready to suck.
The Dusty is just a blower mounted about 3 metres up wot blows straight outside.
I had a handbashed earlier version and although it wouldn’t suck chips is would pull 90% of and sanding dust.
New right angle banjo in 1” plate on the RS for getting at the back of stuff in the gap.
Change Lever knob removed to give clearance for gouge handles.
H.Jimcracks for the rich and/or wealthy. (aka GKB '88)
-
11th November 2022, 08:48 PM #3GOLD MEMBER
- Join Date
- Apr 2019
- Location
- NSW
- Age
- 38
- Posts
- 1,135
not a bad idea considering the big push to go LED rather then the typical high bay.
beats just turfing them I suppose
Similar Threads
-
Repurposing unwanted hand tools on Geelong
By aljenit in forum HAND TOOLS - UNPOWEREDReplies: 0Last Post: 17th November 2020, 11:58 AM -
Bell mouth hoods
By russ57 in forum DUST EXTRACTIONReplies: 11Last Post: 16th October 2019, 09:17 AM -
Repurposing bits from an old (?) cedar chest of drawers - ideas?
By Libertine in forum WOODWORK - GENERALReplies: 0Last Post: 24th July 2013, 07:51 PM -
Repurposing Carpenters Table - Advice needed
By svselva in forum RESTORATIONReplies: 3Last Post: 18th July 2013, 11:14 PM -
Repurposing old furniture for kids
By RedShirtGuy in forum WOODWORK PICSReplies: 1Last Post: 30th January 2011, 09:41 PM