Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
1st August 2013, 11:15 PM #1
SETTING UP NEW SHED (Air Filters)
Hi all
I have finally moved house and am in the process of setting up the new sheds.
The main area is approx. 6m x 7.5m x 3m h, at this point in time I have installed most of
my fixed dust extraction ( Main Machinery). I have 3 mobile dustys for other equipment.
The problem i'm trying to solve is this
I have installed 1 C/Tec 650cfm room air filter to the centre of shed I do have another one
as it will not be suitable to fit to my smaller shed (4m x 5m) ceiling height to low.
Would it be advantageous to install both in the main shed as this is where my real dust problems are ?
If so should they be positioned facing the same direction or facing each unit opposite to the other. I have assumed they probably
should face opposite to one another creating a circular type air flow.
Any advice would be greatly appreciated.
Brian
-
1st August 2013 11:15 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
2nd August 2013, 12:01 AM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,793
Two room air filters will be better than one, and provided they are equally spaced within the shed it won't matter much how they are arranged.
The room air filter units I have measured were not as efficient at extracting fine dust from shed air as a basic dust extractor with either a needlefelt bag or pleated filter so scrubbing shed air clear of wood dust is more efficiently done by running a DC for some time after the last dust making activity rather than running a room air filter.
One reason for not using a conventional DC to clean shed air after dust making is the noise. This is another reason for putting DCs outside a shed.
However, a problem with DCs located or venting outside a shed is that this drags external air into the shed. While the wood dust content of the fresh air should be lower than what is being dragged out of the shed, external air will still contain dust, and often lots of it, so if you want overall low dust counts (eg for finishing) its better to run a room air filter.
I use an externally located DC to firstly vent the wood dust from the shed and then run a room air filter after that.
-
2nd August 2013, 07:42 PM #3
Thank you Bobl
I took down the Air filter I had installed. (to cntr of shed)
Put the two up equally spaced in the shed today.
Looks ok hopefully works well I think it will because I
was really happy how they used to work in my old sheds.
Once again thank you for the input and advice.
Brian
Similar Threads
-
New And setting up my shed
By spankingpigeon in forum BANDSAWSReplies: 14Last Post: 20th September 2012, 06:26 AM -
New And setting up my shed
By spankingpigeon in forum WOODTURNING - GENERALReplies: 2Last Post: 29th August 2012, 10:09 PM -
I need help setting up my shed-Lathe
By Sainter696 in forum WOODTURNING - GENERALReplies: 13Last Post: 16th April 2009, 05:29 PM -
I need help setting up my shed-Table saw
By Sainter696 in forum TABLE SAWS & COMBINATIONSReplies: 4Last Post: 25th March 2009, 09:52 AM -
I need help setting up my shed
By Sainter696 in forum GENERAL & SMALL MACHINERYReplies: 0Last Post: 24th March 2009, 08:38 PM