Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Retro fitting vice screw
-
11th June 2013, 10:19 AM #1Intermediate Member
- Join Date
- May 2013
- Location
- Brisbane
- Posts
- 38
Retro fitting vice screw
Hi all, I bought an old bench on the weekend and the seller had a bunch of tools from a liquidated workshop in oakey. Glad I didn't take too much cash (and disappointed at the same time). I did grab a woden vice screw most probably out of a black smiths leg vice. It is 28mm od with about 1.5 tpi. It has one threaded collar but at the head end it just has a ball with a hole and a handle running through it.
If I wasn't to use this for a leg vice could I just fix the threaded collar to the leg and drill a clearance hole in the moving jaw and let the ball face rub on a washer? There's probably 10mm of shoulder around the threaded rod on the base of the ball.
A pic would help here I guess, ill try to get one tonight.
http://redzonline.com/computerfiles/images/pic715.jpg
Cheers,
Sean
-
11th June 2013 10:19 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
18th June 2013, 01:16 AM #2
When you say "wooden vice screw" ... it is actually all metal, right?
I put my head on one side thinking of a blacksmith's leg vice with a wooden screw!
Yes it is perfectly useable like you said - they have been on sale like that for at least 100 years ... I saw it recently but cannot remember the company.
You can find these builds online once you figure out the right search terms ... leg vice/metal screw/metal acme/etc
If you cut one or two grooves into the shaft you could have the head section captured into a leg or other type of vice face by a metal plate.
Cheers,
Paul
-
21st June 2013, 01:13 PM #3
Speaka the devil ... Rockhampton Morning Bulletin 1948
Rockhampton MB 1948.JPG
Similar Threads
-
Retro fitting stacked Dado Blade
By marct in forum TABLE SAWS & COMBINATIONSReplies: 2Last Post: 12th November 2010, 11:55 AM -
Twin Screw Vice Fitting?
By Scally in forum THE WORK BENCHReplies: 19Last Post: 24th August 2009, 11:20 PM -
Fitting old Tail-Vice Screw
By rhancock in forum HAND TOOLS - UNPOWEREDReplies: 6Last Post: 13th April 2007, 08:05 AM -
Fitting Bench Vice
By Strungout in forum WOODWORK - GENERALReplies: 8Last Post: 19th October 2006, 06:11 AM