Thread: New Router table

As funds were low and I had a choice between two separate tools I chose to make a router bench (seeing as I had free timber floating about)

Start of the lay-out:


More layout with Ply & Steel insert (this eventually is sanwitched between layers of Ply):


All done up:


The fence with guide bolts on end shown:


Back of fence (bitsa fence, but hey budgets are what budgets are):


Close-up:


The table was built with a dual purpose in mind.

I needed another extension table for my little Triton saw table and of-course for use as a router table. Table is built from 90x35 non structural timber and Melamine Chip board..

If you require dimensions I am happy to post those.