Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: A new vice
-
18th April 2010, 04:01 PM #1Senior Member
- Join Date
- Jun 2005
- Location
- Planet Earth
- Posts
- 477
A new vice
I added a twin screw vice to the test bench this morning.
It is 610mm between the screws.
I have had the screws for a while and I finally got sick of long thin stock flexing when I planed.
Masking tape is the fancy ends for the handles.
-
18th April 2010 04:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
19th April 2010, 09:23 AM #2
I see that your bench is small but then again the new vise is large.
Very nice.
Similar Threads
-
Pin Vice
By Howdya do that in forum BOX MAKINGReplies: 15Last Post: 8th March 2007, 07:06 PM -
Is this vice ok?
By Landseka in forum WOODWORK - GENERALReplies: 14Last Post: 10th November 2006, 01:21 AM -
Tail vice/End vice
By silentC in forum POLLSReplies: 17Last Post: 30th November 2005, 08:19 AM -
yet another vice :-)
By routermaniac in forum WOODTURNING - GENERALReplies: 7Last Post: 4th April 2005, 08:40 PM