Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: Assembling Golding Lathe
-
21st April 2008, 05:02 PM #1
Assembling Golding Lathe
The intermediate shaft between the Motor and the Drive Shaft on the Head Stock had been misaligned and stuffed the two bearings and the shaft.Pic shows the new shaft in the making,this time I am fitting two circlips to hold the lateral movement.
Another use for the mod with the Dremel and a cutting disk to create the groove for the circlip.
Progress taking place. Peter
-
21st April 2008 05:02 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
21st April 2008, 06:14 PM #2
Peter looking good like the dremel set up
check your PM's & email's
Ray
-
21st April 2008, 11:30 PM #3
Intermediate Lay Shaft finished
Fitted two new bearings,completed and fitted the new shaft,captive on either side of the pulley cut the grooves,fitted two circlips,no lateral movement now.
Now have to align the motor to lay shaft at the motor end.
Lubricated the headstock bearings.
End view shows the headstock is swivelled with the motor.
Last pic indicates some of the remaining gear to locate where it fits and clean up.
Used the Dremel set up to cut the shaft to length,stainless steel rod from a photocopier rail,hard a hell but the cut off disk handled it on the dremel.
Peter
Sorry the last image is too big,do the extras another day.
-
22nd April 2008, 08:58 AM #4
Peter how much lateral movement was on the shaft
with the few Ornamental lathes I have seen the shaft moves lateral so the cutting head is pulled away from the work during the process.
Ray
-
22nd April 2008, 02:00 PM #5
Ray
The play was in the intermediate shaft ie the lay shaft where there should be no play.
I am convinced there are ornamental lathes and decorative and hope to end the confusion in definition one day.
Booked the Friday and Saturday 14 and 15 bus to Sydney in June for WWW Show got the 15 bucks each way fares.
Take care Peter
-
22nd April 2008, 04:19 PM #6
not bad Peter now all you need is tickets
Peter Check your dates Friday 13th is the first day
http://www.workingwithwood.com.au/sydney/index.htm
Similar Threads
-
Golding Wood Lathe
By Penpal in forum WOODTURNING - ORNAMENTAL TURNINGReplies: 19Last Post: 20th April 2008, 12:19 AM -
Assembling Pens
By nifty52 in forum WOODTURNING - PEN TURNINGReplies: 21Last Post: 28th March 2007, 12:31 AM -
Golding lathes
By hughie in forum WOODTURNING - GENERALReplies: 4Last Post: 9th November 2006, 12:43 PM -
assembling a tsc10hb
By Redback in forum WOODWORK - GENERALReplies: 6Last Post: 20th August 2005, 09:21 PM -
Assembling the TSC10HB
By dazzler in forum HAND TOOLS - POWEREDReplies: 35Last Post: 5th July 2005, 09:36 AM