Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 20 of 20
Thread: Golding Wood Lathe
-
17th April 2008, 09:21 AM #16
Penpal its sounds so tempting I'd like to ask if I take a drive down to ACT could I come and view it. whats a 3 hours drive besides LOML can visit her cousin.
Photo's to quell my inquisitiveness.
Damn where did that old Spirograph go.
Must have been the strangest sight Toni a huge box why? whats in it? all the while you r heart pounding that it doesn't drop fall get broken is still in one piece.
Then unpacking it
-
17th April 2008 09:21 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
17th April 2008, 03:58 PM #17
Wheelinaround
You are welcome any time to visit I have lots of ideas to share this lathe will take a while to figure or configure,as a lathe it will run right now however I have to be satisfied it runs its best possible.I have had a Waldown double ended buff unit for ages,never been used,fitted an old three phase motor that proved faulty then fitted another I had but it took half a day to shift the old pulley off the shaft some ideot had glued the thing with the allen key to the shaft,never know what you will find with purchases.
Send me a pm and I will give you my phone number,Home address and E mail address.Peter
-
17th April 2008, 04:25 PM #18
Thank you Peter pm sent
Now to convince LOML a visit to ACT would be great
Oh where's your photo's o the pride and joy
-
19th April 2008, 08:57 PM #19
have you got it yet?
-
20th April 2008, 12:19 AM #20
Toni
Yes refer page 1. I have and still mystified by bits will reassemble the lathe during the week and take pics then.
Peter
Similar Threads
-
Wood lathe used as metal lathe?
By Kiwi Greg in forum WOODTURNING - GENERALReplies: 15Last Post: 25th February 2013, 05:57 AM -
GMC Wood lathe
By smidsy in forum WOODTURNING - GENERALReplies: 36Last Post: 28th September 2008, 02:10 PM -
Golding lathes
By hughie in forum WOODTURNING - GENERALReplies: 4Last Post: 9th November 2006, 12:43 PM -
Wood Lathe
By WoodWorker27 in forum WOODTURNING - GENERALReplies: 4Last Post: 7th August 2006, 09:05 PM