Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Dust extractor
-
10th April 2022, 03:17 PM #1
Dust extractor
total tools extractor
motor replaced with 3 ph 2 HP and LENZE drive
it is set to run at 65 hz giving it more extraction power huge difference
selling as i upgraded shed and extractor
hasd new felt bags Larger than original
opening for 150 mm pipe
$150 ono
just need it gone
so all offers looked at
motor and drive worth more than that alone
sorry about photos
20220402_142648.jpg
20220402_142628.jpg
20220402_142618.jpg
20220402_142638.jpg
-
10th April 2022 03:17 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
11th April 2022, 09:11 AM #2Intermediate Member
- Join Date
- Jan 2022
- Location
- Brissie
- Posts
- 42
I might be up for this one as well. Just need to work out if can run it on single phase or swap out motor
-
11th April 2022, 10:53 AM #3SENIOR MEMBER
- Join Date
- Jul 2014
- Location
- Brisbane
- Posts
- 937
The plug in the photo is a 3pin single phase. The Lenze VSD is wired so the 3 phase motor can be driven from a single phase supply.
-
11th April 2022, 11:45 AM #4.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,795
Just a heads up that @ 65HZ it's going to draw a lot more than 10A so at least a 15A circuit will be needed. If it doesn't draw more than 10A then that means the ducting and Machinery were too choked to move enough air.
-
17th April 2022, 03:24 PM #5
Sold
Similar Threads
-
N.S.W. Jet Dust Extractor
By nicaboo799 in forum WOODWORK - Tools & MachineryReplies: 10Last Post: 5th September 2020, 02:37 PM -
WANTED:QLD. Felder AF22M Dust Extractor or Baileigh DC-2100C cyclone Dust Extractor
By woodchopper in forum WANTED & WANTED TO BUY - in AustraliaReplies: 0Last Post: 15th August 2019, 12:06 AM -
N.S.W. Jet Dust Extractor
By Rockyhollis in forum WOODWORK - Tools & MachineryReplies: 3Last Post: 12th April 2018, 10:41 AM -
Woodman CT-60 Dust extractor, A compact yet powerful extractor.
By sicd_steve in forum WOODWORK - Tools & MachineryReplies: 0Last Post: 19th April 2017, 10:29 AM