Thread: Festool MFT/3 with a lot of accessories

It is time to part ways, sadly, with my Festool MFT/3 table.

It was a great tool when I was getting started but I now do not have the space and with new machines planned will use less and less (and get by with foam sheets on the floor otherwise). I also need to reclaim the space it takes up (I find setting up and deploying annoying).

So for sale is a Festool MFT/3 with accessories. Pictures showing state of the MDF top and only damage are below:

PXL_20220819_013654166 (1).jpg

PXL_20220819_013710001.jpg

What is included is what is shown in photo which is:

* Festool MFT/3 set with fence and mitre gauge etc
RRP $1,595 - MFT 3 Multifunction Table Set)

* Stabilising cross bars (installed)
RRP $245 - Cross Brace Supports for MFT Table

(Yes I know it's a crime they're not included)

* Clamp set and 2x fastening clamps (RRP $219 and $85). Note one jaw missing on clamp set - may be able to find. You can still use the clamp against the edge of a piece.

* 4 x Parf super dogs
(RRP $64 each - UJK Technology Parf Super Dog | Carbatec)

A "slop stop" is installed on the guide rail (a little plastic holder to prevent side-to-side slop in the guide rail.

Some notes on condition/damage:

* The MDF cut has kerf marks as shown. Happy to provide a better photo. It can of course be flipped around lengthways for a near-new side or flipped over

* The guide rail splinterguard has some gouge in one area where I had an accident and the guide rail itself gouged a little. I mention as the replacement splinterguards are a little pricey.

* The guide rail has some nicks that I think you can see but close-ups are available.

In the interests of a quick sale to forum member who tend to be reliable and not a rando off gumtree etc I am willing to price the lot for a quick sale at $1,400 - for pickup in inner south Brisbane.