Thread: hf-50 Bench Top Router 1500W motor

Scheppach German technology and built quality router table. I've had it for a number of years, but only used it twice and just a week ago placed it in the shed.
It has a good strong 1500w 240v motor so it's single phase.
It's also variable speed starting at 8000rpm and can reach up to 24000rpm by simply turning the dial located at the front just above the on/off buttons
The spindle can be raised or lowered, the maximum height can be reached is 40mm
To change cutters there is easy access to the spindle lock.
Two collets came with the router 1/4" and 1/2", I only used 1/2" and have no clue where I've placed 1/4" collet. They are not very expensive and can bought if needed in any hardware store.
The stand was an additional accessory that I bought, I know I paid through my backside for it, but is needed unless you do want to place the router on your bench.
The fence that came with it unfortunately wasn't square so I made my own. I don't have the original fence any longer.
100mm dust chute is provided
2 spanners is provided
1 Mitre guide is provided
The tape measurements were stick on and they came off with age.

This is a very powerful machine and cut's square since I replaced the fence. I only used it twice before I went back to moulding planes. I've always been a hand tool woodworker and thought machinery would bring me equal enjoyment but it hasn't. I've kept it for so long in case I changed my mind, but I haven't and it's just taking up room.

This router table will serve its new owner loyally for the duration of his life.

Brand new without a stand is $363
I'm offering the router table with a stand for a low $250

I guess shipping would be too expensive and I don't want to lug it around either, so it's pick up only unless you organise your own shipping and get the courier to pick it up.