Thanks: 
Likes: 
Needs Pictures: 
Picture(s) thanks:
Results 1 to 5 of 5
Thread: Scheppach 12 Table Saw
-
1st August 2020, 09:32 PM #1
GOLD MEMBER
- Join Date
- Nov 2005
- Location
- West Gippsland, Vic
- Age
- 72
- Posts
- 4,608
Scheppach 12 Table Saw
Selling as I need the space.
Scheppach 12” table saw and accessories.
2HP 10amp Motor
3 TCT blades, 1 fitted - 2 need sharpening.
Sturdy pressed steel frame and table.
Good condition.
Asking $300 ono
Pick-up only (COVID-19 safe non-contact) from Yarragon,
01C05150-3F47-4D22-A89A-5EEDE232680A.jpg16480FD5-8956-4237-9CA2-E4E95AC0ADBD.jpg73A6496C-D534-4B9E-A6BD-97F26AC5F447.jpg01C05150-3F47-4D22-A89A-5EEDE232680A.jpgIf you never made a mistake, you never made anything!
-
1st August 2020 09:32 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
4th August 2020, 12:01 AM #2
GOLD MEMBER
- Join Date
- Nov 2005
- Location
- West Gippsland, Vic
- Age
- 72
- Posts
- 4,608
DOWN DOWN
GOTTA GO
$200 ono.If you never made a mistake, you never made anything!
-
8th August 2020, 10:57 PM #3
GOLD MEMBER
- Join Date
- Nov 2005
- Location
- West Gippsland, Vic
- Age
- 72
- Posts
- 4,608
Ok. Reduced to less than the cost of three TCT Blades.
$150
pick up only. Yarragon 3823
If you never made a mistake, you never made anything!
-
9th August 2020, 07:00 AM #4
Senior Member
- Join Date
- Jul 2013
- Location
- Townsville NQ
- Posts
- 100
Why isn’t this in Townsville???
-
9th August 2020, 06:00 PM #5
GOLD MEMBER
- Join Date
- Nov 2005
- Location
- West Gippsland, Vic
- Age
- 72
- Posts
- 4,608
Damn. I spent last winter camped around Crystal Creek Beach. Was going again this year but my dog is too ill to travel. So it could well have been up there.
If you never made a mistake, you never made anything!
Similar Threads
-
Scheppach thicknesser table seized up
By BUNDYMARK in forum WOODWORK - GENERALReplies: 5Last Post: 29th May 2010, 12:06 AM -
Scheppach 315mm Portable Table Saw
By Jack52 in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 29th December 2006, 03:14 PM -
scheppach table saws
By johanxh in forum TABLE SAWS & COMBINATIONSReplies: 0Last Post: 8th September 2006, 02:45 AM -
Scheppach TKU Table Saw
By pnienaber in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 23rd June 2001, 08:58 PM
