Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Three Phase Motor
-
2nd September 2020, 12:19 AM #1GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
Three Phase Motor
Preferably in the Southern areas of Sydney or Wollongong. Not fussed on big horsepower and preferably with a drive pulley. Obviously it will be a pick up so it needs to be roughly in the areas specified.
CHRIS
-
2nd September 2020 12:19 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
9th September 2020, 05:06 PM #2GOLD MEMBER
- Join Date
- Jul 2011
- Location
- In between houses
- Posts
- 1,784
-
9th September 2020, 06:05 PM #3GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
-
10th September 2020, 08:48 AM #4GOLD MEMBER
- Join Date
- Mar 2018
- Location
- Sydney
- Posts
- 1,166
well Chris, here might be some planets aligning. I have to go see RB this weekend, and I live at Sutho, so I might be able to assist getting it closer to home base?
-
10th September 2020, 11:54 AM #5GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
Thanks Poundy and RB, I was concerned that the motor will be very noisy in use and above all it must be usable with a VFD as well. NCArcher has told me that that is not the case so if you can pick it up I would be grateful as it saves me about a four hour drive.
Riverbuilder, let me know how much you want for it and thanks for the help.CHRIS
Similar Threads
-
fitting single phase motor to old 3 phase lathe
By Sebastiaan76 in forum WOODWORK - GENERALReplies: 15Last Post: 11th February 2016, 11:39 PM -
Replacing A Single Phase Motor With A Three Phase Motor....................
By matthew_g in forum METALWORK FORUMReplies: 26Last Post: 1st May 2015, 04:42 PM -
rewire 3 phase motor to single phase
By thorens in forum METALWORK FORUMReplies: 36Last Post: 5th September 2014, 07:16 PM -
Looking to swap a 2Hp single phase motor for 1.5 or 2Hp 3-phase motor
By jhovel in forum METALWORK FORUMReplies: 7Last Post: 10th March 2014, 07:26 PM