Thread: Clamp rack plans

Hi,

I built this clamp rack a couple of weeks ago from plans I created in Sketchup from a single sheet of 17mm CD plywood.

34B6CEA2-5F29-4D8C-B709-6479278B8FA2.jpg

I tried four times but I've given up trying to correct the orientation of the photo

The design was inspired by this link:

https://jayscustomcreations.com/2015...al-clamp-rack/

I have attached the cutting list I created using CutList in PDF and the original Sketchup model.

The layout shows the design going on to a second sheet of plywood. I cut these two parts from some reclaimed pine that I had to spare obviating the need to cut up a second sheet.

The rack is attached to the wall by two french cleats.

Clamp Rack.pdf
Clamp Rack.skp

If I were to do it again, I would cut the wider slot even wider. As you can see, the wider pipe clamps I have don't fit in the slot except by the clamp head. I could take it off the wall and cut them wider on my sliding table saw but I frankly can't be bothered at the moment. It's still a thousand percent better than the arrangement I previously had!

Feel free to use and adapt as you like.