Needs Pictures: 0
Results 1 to 3 of 3
Thread: Clamp rack plans
-
11th April 2017, 10:09 PM #1
Clamp rack plans
Hi,
I built this clamp rack a couple of weeks ago from plans I created in Sketchup from a single sheet of 17mm CD plywood.
34B6CEA2-5F29-4D8C-B709-6479278B8FA2.jpg
I tried four times but I've given up trying to correct the orientation of the photo
The design was inspired by this link:
https://jayscustomcreations.com/2015...al-clamp-rack/
I have attached the cutting list I created using CutList in PDF and the original Sketchup model.
The layout shows the design going on to a second sheet of plywood. I cut these two parts from some reclaimed pine that I had to spare obviating the need to cut up a second sheet.
The rack is attached to the wall by two french cleats.
Clamp Rack.pdf
Clamp Rack.skp
If I were to do it again, I would cut the wider slot even wider. As you can see, the wider pipe clamps I have don't fit in the slot except by the clamp head. I could take it off the wall and cut them wider on my sliding table saw but I frankly can't be bothered at the moment. It's still a thousand percent better than the arrangement I previously had!
Feel free to use and adapt as you like.
-
11th April 2017 10:09 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th April 2017, 10:22 PM #2GOLD MEMBER
- Join Date
- Nov 2012
- Location
- SE Melb
- Age
- 64
- Posts
- 1,278
Nice one Mark. I always want one of these.
34B6CEA2-5F29-4D8C-B709-6479278B8FA2.jpg
I have put the picture the right way up.
-
11th April 2017, 10:36 PM #3
Thank you. It was driving me nuts!!
Similar Threads
-
Clamp rack
By pellcorp in forum WOODWORK - GENERALReplies: 5Last Post: 15th January 2013, 07:50 PM -
Clamp Rack Ideas
By Snarf in forum FURNITURE, JOINERY, CABINETMAKING - formerly BIG STUFFReplies: 6Last Post: 2nd September 2009, 02:34 PM -
Simple Clamp Rack
By wheelinround in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 10Last Post: 11th January 2009, 11:41 AM -
Clamp Rack +
By Bob38S in forum WOODWORK - GENERALReplies: 19Last Post: 18th August 2008, 12:11 PM