Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Shelving span between uprights
-
29th October 2011, 04:25 PM #1
Shelving span between uprights
I'm going to make them similar to this design:
The unit needs to be 3m long, so would be nice to have the vertical spans at regular intervals (1m or 1.5m), but really need to know what span is realistic, without compromising the loading ability.
While I'm at it, I expect to use green tongue, ripped in half to about 450mm for the shelving as it's the cheapest product I can find in uniform size, and really don't want deep shelves.
Any advice would be greatly appreciated.
-
29th October 2011 04:25 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th October 2011, 08:52 PM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,813
What's your expected load?
Timber?
Steel?
A few Power tools
A lot of power tools
Bags of cement?
If you want a 1.5m span and use 90 x 35s you should be able to put 120 kg on a pair of those without a problem.
-
29th October 2011, 09:44 PM #3
And if you think you're going to overload it, you can double the rails too - in the past I've used one in front and one behind the uprights.
Cheers, Richard
"... work to a standard rather than a deadline ..." Ticky, forum member.
-
31st October 2011, 08:33 AM #4
Thanks for the responses. As for loading, I want them to be good for anything type loads (save for engine blocks etc).
I love Richard's idea, or adding additional rails if required. As such, I'll start with the rails on the outside of the uprights, which will allow me to retrofit additional rails on the inside at a later date if required.
-
31st October 2011, 09:24 PM #5
Glad to help. Wouldn't it be easier to start off with rails on the inside and add rails on the outside later?
Cheers, Richard
"... work to a standard rather than a deadline ..." Ticky, forum member.
-
1st November 2011, 11:21 AM #6
Have a look at my bench frames(my little shed ) I have done half check joints on all the uprights and rails this is much stronger that just bolting through the timber. Although bolting may be adequate for your needs, .
the shelves shown on the link would hold most items , but an engine block might be pushing the friendship.
Jeff
-
1st November 2011, 01:37 PM #7
Ta. I was concerned that rails on the inside first would mean when I add rails outside later, the shelf would be too narrow. Now that you mention it, there's no reason I can't just make them full width now, and having the rails not at the outside extremes, would also reduce the shelf board deflection in the middle.
vk4: Yes, I'll check the rails into the uprights, as it'll help me sleep better at night.
Similar Threads
-
Where to buy second hand long span shelving in Melbourne?
By Com_VC in forum THE SHEDReplies: 8Last Post: 3rd January 2011, 07:43 PM -
Shelving
By Corunetes in forum WOODWORK - GENERALReplies: 19Last Post: 28th May 2009, 11:45 PM -
shelving
By readnik in forum WOODWORK - GENERALReplies: 6Last Post: 24th December 2005, 05:16 PM