Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: casting a brass nut
-
25th May 2019, 10:20 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
casting a brass nut
Hi all .. Had this in the general section.. some may already have seen it..I need to reproduce this nut for a vintage vice I am working on.. thread diameter is 7/8" or 22.2 mm.. pitch is just over 4 turns to the inch..
because of the mystery number of turns, and as it is brass, would it be possible to cast a new nut around the screw ???
Ken100_3138.jpg100_3140.jpg100_3137.jpg
Attached Images
- 100_3138.jpg (132.0 KB)
- 100_3140.jpg (153.0 KB)
- 100_3137.jpg (120.4 KB)
Read the full thread at metalworkforums.com...
-
25th May 2019 10:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Anyone have any experience casting brass?
By Jim Ferrous in forum METALWORK FORUMReplies: 7Last Post: 27th September 2013, 02:32 PM -
Casting about for cast iron casting ideas
By Graziano in forum THE FOUNDRYReplies: 49Last Post: 1st April 2012, 12:05 PM -
Casting a brass nut.
By Skew ChiDAMN!! in forum METALWORK FORUMReplies: 6Last Post: 21st November 2011, 01:04 PM