Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 21 of 21
-
7th February 2021, 03:32 PM #16Senior Member
- Join Date
- Jan 2005
- Location
- Campbelltown NSW
- Age
- 77
- Posts
- 335
What are the symptoms. Does this help? Is the switch positioned so the door closed pushes the lever.
8365CEAB-E200-4334-82FA-FD05D645AFAE.jpg
-
7th February 2021 03:32 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
7th February 2021, 05:43 PM #17Senior Member
- Join Date
- Nov 2013
- Location
- Sydney
- Posts
- 259
-
8th February 2021, 10:08 AM #18Senior Member
- Join Date
- Nov 2013
- Location
- Sydney
- Posts
- 259
The micro switch interrupts the power to the motor once the door arrives. Would you please
show how to start the cycle again ?
Thank you,
Regards,
Gus
-
8th February 2021, 11:40 AM #19Senior Member
- Join Date
- Nov 2013
- Location
- Sydney
- Posts
- 259
apple8,
I have been experimenting. Using a general purpose relay, wiring its NO output to the motor, found that by wiring a momentary push switch to the +, pushing it starts the door movement, releases the micro switch blade. That in turn disconnects the motor once the door arrives. This seems to work well.
Do you see a possible problem ?
Thank you,
Regards,
Gus
-
8th February 2021, 11:40 AM #20Senior Member
- Join Date
- Jan 2005
- Location
- Campbelltown NSW
- Age
- 77
- Posts
- 335
Hold down the momentary switch until it starts moving and the micro switch operates. That circuit only works for one cycle each time the button is pressed. If you want multiple cycles swap the momentary action button for an on/off switch, with the switch on it will keep cycling until turned off and then finish the cycle when the door closes.
-
8th February 2021, 02:37 PM #21Senior Member
- Join Date
- Jan 2005
- Location
- Campbelltown NSW
- Age
- 77
- Posts
- 335
Similar Threads
-
240v Power Relay Board
By Lappa in forum ELECTRONICSReplies: 10Last Post: 6th January 2021, 08:57 PM -
Relay Problem
By kiwiken in forum CNC MachinesReplies: 10Last Post: 22nd April 2013, 07:25 PM -
Rework of the 5v to 24v relay driver
By Malibu in forum ELECTRONICSReplies: 16Last Post: 27th January 2013, 06:13 PM -
5v to 24 volt relay driver
By Malibu in forum CNC MachinesReplies: 4Last Post: 23rd January 2013, 07:39 AM -
Load sensing relay for shop-vac
By TTIT in forum DUST EXTRACTIONReplies: 14Last Post: 8th September 2012, 10:10 PM