Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
11th December 2014, 12:46 PM #1
High Current Shunt (500 - 1000 Amps) DIY (RAG Model)
I had to roughly measure the current drawn by my 12 V vehicle winch, and made up a R.A.G. model current shunt as per photos.
It is made from a 304 stainless steel M8 x 100 ISO coarse set screw (aka bolt), and some brass bar, nuts and washers, all ex bits and scrap bins.
The washers are SS316, the nuts zinc plated steel.
Nuts torqued up very, very tight, and the "punched" SS washers are smooth edge side to the brass bar for best connections.
The critical "electrical dimension" is the distance along the bolt between the centrelines of the brass bars, and for my bolt was 48mm.
This was set so as to give a shunt transfer characteristic of 1.0mV per 1.0 amp.
This means that your millivoltmeter directly reads in amps.
So, 400 amps reads as 400mV.
The shunt resistance is 0.001 ohm, and at 500 amps dissipates 250 watts.
Use this shunt at high currents intermittently only; a few minutes on ten minutes off to stabilise the system.
Use at higher currents will be limited mostly by external factors like connecting lead resistance, source internal resistances, and even the resistance of the brass connector bars.
It will work, but special techniques and awareness of limitations are required.
Place your meter leads on the brass near to the nuts.
Meter lead length is mostly of no consequence.
Connect the shunt as shown, not to the end of the bolt using more nuts.
I calibrated my shunt at 10 Amps, a bit low, but I have an accurate millivoltmeter.
If you use an M8 SS304 bolt and brass "lugs" for yours, it will be accurate enough (10% or so), and good enough for the task without calibration.
Must use an M8 SS304 bolt, not SS316, not steel or brass or other.
Test 304 with a strong magnet as slightly magnetic; 316 is (almost) non-magnetic.
Be aware that DVMs have a measurement time lag to display varying currents correctly.
An analog meter will work also, and with less time lag.
Caution connecting up to the battery; this shunt can carry very high current.
Not my original idea; saw it on the web somewhere.
Works well.
cheerio, mike
P1150684lo.jpgP1150680lo.jpg
-
11th December 2014 12:46 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Splinter, the high-performance wooden supercar - a real model at full scale
By crowie in forum SCALE MODELLINGReplies: 2Last Post: 13th September 2014, 08:09 AM -
shapton pro 1000,1500 vs vs sigma power 1000 vs bester 1200?
By Sazman in forum SHARPENINGReplies: 7Last Post: 30th January 2012, 09:11 AM -
How many amps do I *really* need?
By rlincolnh in forum WELDINGReplies: 50Last Post: 29th June 2009, 12:11 PM