Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Incra Router table combo
-
20th September 2014, 03:45 PM #1Novice
- Join Date
- Aug 2014
- Location
- Bathurst
- Posts
- 12
Incra Router table combo
Hi
I have a Incra RT-COMBO3 router table which comes with the table, table top, router plate, super fence system all in metric which cost me $1200 when i purchased in on the 1st of August 2014.
It also comes with a Triton TRA-001 2400w router and is more than powerful for any job, comes with all original accessories like 1/2" collet, 1/4" collet etc.
Also comes with a 6 piece Whiteside metric joinery router bit set to do all the patterns that came with the Incra table package, also include 3 x Incra metric rulers.
The router table fence has been accurately set to a maximum of 0.002 of run out, included also is a wixey wr200 digital height gauge to accurately and precisely set the router bit height.
All of this was purchased between August 2014 and present and has barely been used so is in new condition and has cost me well over $1800.00, unfortunately i must sell due to a back injury.
I am Located in Bathurst NSW which is only a short drive away from Sydney, i would like around $1200 ONO but sensible offers only!
MAKE AN OFFER - 0423 404 364
-
20th September 2014 03:45 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th September 2014, 08:36 PM #2Novice
- Join Date
- Aug 2014
- Location
- Bathurst
- Posts
- 12
Similar Threads
-
Router table for Incra LS
By Big Shed in forum INCRA JIGSReplies: 35Last Post: 31st August 2017, 12:42 PM -
Table Router Combo
By bobcarter in forum ROUTING FORUMReplies: 8Last Post: 24th October 2012, 08:37 AM -
Heads up....router table & incra wonder fence
By minus459 in forum ROUTING FORUMReplies: 5Last Post: 31st August 2010, 02:52 PM -
Incra Router Table
By sbnx in forum INCRA JIGSReplies: 2Last Post: 15th April 2007, 10:25 AM -
Incra Ultra Jig System for router table
By wands in forum ROUTING FORUMReplies: 44Last Post: 10th October 2003, 05:40 PM