Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
9th December 2013, 10:17 PM #1SENIOR MEMBER
- Join Date
- Oct 2012
- Location
- brisbane
- Posts
- 848
Vintage Paulcall 6" Jointer and Table Saw
Up for grabs is this great vintage Paulcall combination 6" jointer and 9.25" table saw. The unit runs on a shared arbor via a single 240V motor. It all runs but could do with a good clean up. There is also a box of bits including mitre gauge, rip fence, spare 6" cutters for the jointer etc. Unlike a lot of these early saws this unit has a rising arbor (rather than rising table) and even includes a good riving knife behind the blade. Hopefully someone can put it back to good use. Bring your buddies to lift it as this is good old fashioned Aussie quality. Iron ore must have been cheap back then. This isn't an auction. Asking $100 the lot. If you can use it just say I'll take it.
-
9th December 2013 10:17 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
9th December 2013, 10:26 PM #2GOLD MEMBER
- Join Date
- Nov 2012
- Location
- Brisbane
- Posts
- 1,809
-
10th December 2013, 01:23 PM #3New Member
- Join Date
- Jan 2009
- Location
- Brisbane
- Posts
- 7
I have a ute but it would be just me doing the lifting. How hard would it be to dismantle for transport? If you think it would be feasible I will take it for $100. I am pretty flexible with collection date and time. Let me know either way.
Regards
George
-
10th December 2013, 06:17 PM #4SENIOR MEMBER
- Join Date
- Oct 2012
- Location
- brisbane
- Posts
- 848
Paulcall sold
Hi George,
It does breakdown quite easily so we'll get it on the back of a ute without too much trouble. PM sent. Sold to you.
Similar Threads
-
vintage(paulcall) 6 inch jointer_Help_
By agent86 in forum ANTIQUE AND VINTAGE MACHINERYReplies: 7Last Post: 17th July 2015, 10:34 PM -
Paulcall Jointer Bearings
By tonysa in forum HAND TOOLS - POWEREDReplies: 4Last Post: 1st May 2006, 08:41 AM