3 Attachment(s)
Taper ground 12" saw plate
I made some measurements of one of the two saw plates that I taper ground. I can do better on consistency but I think the results are pretty good. All measurements are in millimeters. Those measurements with inter-divisional measurement at the limit of the caliper I used are marked (+) or (-) where the reading was above or below the indicated numerical reading. All measurements were taken approximately 3 cm in along the edges as marked.
First the toe:
Attachment 302983
At the heel:
Attachment 302986
And down the tooth line:
Attachment 302987
I don't have a micrometer with a sufficiently deep throat to measure in the center of the saw plate yet.
Cheers,
Rob
1 Attachment(s)
No bath salts so back folding instead.
The salts for the quenching bath have not arrived so I spent the day making backs.
Attachment 305138
These are medium weight brass (bottom and extreme left ) heavy brass (upper left-center) and stainless.
Cheers,
Rob
1 Attachment(s)
After a long delay due to other factors I finally got some of these ready.
Here they are.
These are light brass (LBB), medium stainless (SSM), medium steel (MSB), medium brass (MBB) and heavy brass (HBB). They range from about 9 to 14 inches in length. Listing these on eBay under 'Alamo Toolworks'.
Attachment 331322
Cheers,
Rob