Veener saw and abused tools
Well after being away from the creative zone for a few months?
Due to dealing with the New world order.
It was a fantastic feeling walking into our own home on Friday morning despite the fridge having a small temper spat an letting some good food Rot because the power was off for a few days [emoji3064][emoji3064].
So ,after cleaning up the fridge because I really didn’t have the guts to ask Sal if she minded doing that while I went and played.
So Saturday morning I was back in heaven even if I’m an atheist.
So ,first things first, I gave the teeth another couple of rounds with a 150 mm (6 inch [emoji17])saw file.
That got most of my crappy stuck in Melbourne teeth sorted out.
This was then followed up by creating a bevel of approximately 23.67 degrees, or what my hands thought looked liked 23.67 degrees,
This was accomplished using some new to me USSR Mill Files I’m in the mood for the new world order , I hope George is happy , with me following the Party lines.
https://uploads.tapatalk-cdn.com/202...53c7ee47ea.jpg
Next, I needed to attach the saw plate to the frame,this unfortunately involved tool shopping,and travailing which I hate doing on the weekends,the travailing bit.
So ,off I went to the tool shop for a M4 .75 bottoming tap , but I sort of figured while I was there I may as well get a M4 starting tap an the innermetint tap too plus bugger it ,I take an M4 .75 Die as well.
Luckily I have some nice tap handles or the budget would have really have been smoked.
I mean the set is better than just a bottoming tap , right.
So ,once back in the creative zone and with some suitable music blasting away.
Two little holes at 3.2 mm were drilled into the frame ready to be tapped out.
3.2 being only .1 smaller than the recommended tapping drill hole.
These were then tapped using the bottoming tap only as there only 3mm ish deep,hence I didn’t start with the starting tap.
Next ,the saw plate was marked out ,and it to had two holes drilled using my solid carbite
Spade bit a must have in my opinion for drilling saw plate.
Finally ,after all that ,two M4 screws were cut down to about 4 mm in length.
And the parts became one, coool
https://uploads.tapatalk-cdn.com/202...c9ec7f2719.jpg
https://uploads.tapatalk-cdn.com/202...e29e19967b.jpg
https://uploads.tapatalk-cdn.com/202...ba89a29826.jpg
https://uploads.tapatalk-cdn.com/202...2d08ed54c0.jpg
So ,after starting with nothing in the new world order trial period.
The Coronavirus veneer communist party saw is done.CVCP
O Ye nearly forgot, yep it even cuts quite nicely I must say,even if it has questionable origins.
Cheers Matt.
Ps I really hate tho screws too, I think they will go [emoji3064]