Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: My Rotary Stuff
-
30th October 2014, 09:56 AM #1
My Rotary Stuff
WOW.
I have the Dremel 3000, The kit included Flexi Drive and a plethora of other bits and pieces. Since that purchase I have gone Dremel crazy.
A router table and hand held router, work station. Plus a Moto saw. No probs so far, a very versatile kit for small work, I like to create clocks and will be starting on doll houses as soon as time allows.
I was suckered into a Twist a Saw. Spose it comes under this forum. It died on the third attempt, most of the accessories were inter mingled with the Dremel stuff, however the Twista saw mob replaced the whole kit and kaboodle with a newie.
Ok a comparison. The Dremel is my weapon of choice, however I use 1/4 inch router bits in the twist a saw as a handy palm router. The twist a saw accessory case has an informative index so identifying bits is a lot easier.
Was trying to remove screws from a door hinge, screw heads full of paint and bashed beyond use. Simple Dremel to the rescue. Used a metal cutting wheel to cut a new slot, ta da screw succumbed Dremel power and was removed easily. ( Think that makes sense)
If only Dremel came up with a bit case similar to a drill bit case.
Any way enough.
Happy Dremeling
PeteI tried to be normal once.
Worst 2 minutes of my life.
-
30th October 2014 09:56 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
30th October 2014, 06:29 PM #2
Kool stuff Pete
Like you I'm a little Dremel Crazy!
I grabbed a Stylus the other day.
It's already proved to be a handy little addition.
You can leave it setting in the charger and it's right to go when ever you wont.
It's great for little jobs at a moments notice.
The only thing that has taken me a little getting used to is that the grip (handle) is a bit different.
At the moment most of the time I turn it upside down so that the grip is out of the way!
Anyway mate as you say happy Dremeling!
Cheers
Trev.
Similar Threads
-
rotary table
By tanii51 in forum METALWORK FORUMReplies: 24Last Post: 9th June 2014, 07:34 PM -
Rotary broaching
By morrisman in forum METALWORK FORUMReplies: 7Last Post: 29th May 2013, 12:21 AM -
Which rotary table??
By xr6t in forum METALWORK FORUMReplies: 20Last Post: 5th March 2010, 09:22 AM -
Rotary Vice
By jayw81 in forum METALWORK FORUMReplies: 9Last Post: 24th November 2009, 07:18 PM