Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Clutch slave cylinder
-
4th March 2022, 08:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,434
Clutch slave cylinder
I sent off for a hydraulic clutch slave cylinder and some hoses, they arrived today and I was pleasantly surprised. The slave cylinder mounts where the original cable was and pulls on the lever attached to the course thread screw. It was cheap and is pretty darn good quality, just not sure it will work that well as the bore is only around 12_14mm. Tomorrows job.
Some hydraulic hoses also arrived, these were advertised as 'braided' but certainly there is no external braiding. They are quite small in diameter and appear to be made of some sort of plastic with braiding of some sort under the clearish outer surface. The smaller of the two came with three banjos: straight, 28 degrees and 90 degrees. Again, they appear to be quite good quality.
The slave cylinder and hoses were only bought to play with, but if everything works ok, I may look at the hoses for brake lines. I'll be on the lathe again shortly to make a slave cylinder that pushes on the clutch actuating rod, not a fan of the course threaded screw actuator.
Attached Images
- WIN_20220304_16_25_57_Pro.jpg (259.5 KB)
- WIN_20220304_16_25_42_Pro.jpg (219.1 KB)
- WIN_20220304_16_25_19_Pro.jpg (144.6 KB)
Read the full thread at metalworkforums.com...
-
4th March 2022 08:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Resleeving brake slave cylinder
By .RC. in forum METALWORK FORUMReplies: 36Last Post: 21st January 2013, 05:02 PM -
Bench Slave
By Woody1 in forum WOODWORK PICSReplies: 9Last Post: 3rd November 2010, 07:46 PM -
slave clock
By lonesomebob in forum CLOCKSReplies: 5Last Post: 8th June 2010, 12:31 AM -
anyone want a slave (in nowra)
By PaulS in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 2Last Post: 17th October 2005, 10:17 PM