Does anyone have experience of shot peening engine parts?

I have a NOS set of old Morris 4 ring pistons, a aftermarket brand . These are heavy pistons which I think means they have a high iron content. These type of pistons normally have a thin tin coating , the tin coating aids the running in process. In this case the tin has come away or fallen off after many years of storage.

Years ago I shot peened a set of used chevy iron pistons , I actually used a fine sand but I think the professionals use glass or ceramic beads . Anyway the chevy pistons have been running without any problems. I am wondering If I should do the same with these Morris pistons?

piston.jpg
Attached Images




Read the full thread at metalworkforums.com...