THIS IS YOUR FIRST VISIT - PLEASE NOTE:
REGISTER before you can post, view all the pictures, see all threads
Registering will also stop those annoying popup link ads from
THESE METALWORK FORUMS
ARE CLOSED FOR POSTING
The new Metalwork Forums can
be found here >
I have a worn spring saddle on my Jeep rear axle housing , the spring bolt centre locating hole is elongated to a large degree . I am thinking of welding up the worn area and then boring the hole to size .. I think the metal is cast steel , the saddles are welded to the housing at the factory. Somebody on another forum suggested boring the hole oversize then fit a bush .
20200326_100213.jpg (79.5 KB)
Read the full thread at metalworkforums.com...
Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.
This website and its content is copyright of U-Beaut Enterprises. Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following: ♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only ♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge Woodwork Forums as the source of the material.
You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.