Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Emco Maximat Mentor 10
-
11th March 2019, 10:10 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,401
Emco Maximat Mentor 10
As a Newbee Im not sure if this is the right area to post this...so please let me know if there is a more appropriate spot.
I picked up my first lathe yesterday and as you can see it is pretty grubby.
IMG_0458_800x600.jpgIMG_0459_800x600.jpgIMG_0460_800x600.jpgIMG_0461_800x600.jpgIMG_0462_800x600.jpg
The rubber edge seal around the top of the cabinet is just sticky gunge
IMG_0463_800x600.jpg
The switch box will need a good clean. As this machine is a 3Ph 2 speed Dahlander wound motor I am yet to work out a solution to get it running on 240V with VFD. May need to totally rehash the switch box with guidance from profesional people
IMG_0464_800x600.jpg
The box of goodies that came with it.
IMG_0457_800x600.jpg
I intend to start from the ground up on this old girl.... and no doubt will need advise on various aspects of the build.
Thanks
Gaza
Attached Images
- IMG_0464_800x600.jpg (79.1 KB)
- IMG_0463_800x600.jpg (56.3 KB)
- IMG_0462_800x600.jpg (78.1 KB)
- IMG_0458_800x600.jpg (69.8 KB)
- IMG_0459_800x600.jpg (70.6 KB)
- IMG_0460_800x600.jpg (56.3 KB)
- IMG_0461_800x600.jpg (65.6 KB)
- IMG_0457_800x600.jpg (79.8 KB)
Read the full thread at metalworkforums.com...
-
11th March 2019 10:10 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Emco Maximat super 11 first lathe
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 23rd November 2018, 04:00 PM -
Emco Maximat Wiring Diagram
By wheeler727 in forum METALWORK FORUMReplies: 0Last Post: 17th January 2012, 10:46 PM -
Emco Maximat V10 Lathe
By Anorak Bob in forum METALWORK FORUMReplies: 20Last Post: 1st October 2011, 08:22 PM -
Emco Maximat V10-P
By SurfinNev in forum METALWORK FORUMReplies: 5Last Post: 20th September 2011, 06:28 PM