Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Rexman Bull Gear locking pin
-
12th July 2020, 07:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,403
Rexman Bull Gear locking pin
Does anyone know what the original retaining set-up was for a Rexman Bull Gear locking pin?
This is an earlier, relatively small flat-belt model.
IMG_0278.jpg
I am helping a friend get one back into service and this (whatever it was) is missing. The screw to the left of the pin in the following photo has a cross-hole drilled in the head and that indicates perhaps some sort of spring. However, the pin itself has no grooves to locate it halfway out and can be pulled out completely so was it intended to be removed completely for back-gear operation and have something that folded over the back of the pin in normal operation?
IMG_1027.jpg IMG_1028.jpg
Any insight gratefully received.
Attached Images
- IMG_0278.jpg (187.7 KB)
- IMG_1027.jpg (241.4 KB)
- IMG_1028.jpg (160.3 KB)
Read the full thread at metalworkforums.com...
-
12th July 2020 07:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Tight fit for bull gear ?
By phelum in forum THE HERCUS AREAReplies: 4Last Post: 19th December 2013, 07:44 AM -
Broken Myford ML7 Bull Gear
By swarf4ages in forum METALWORK FORUMReplies: 9Last Post: 16th September 2012, 03:31 PM -
Hercus Model A Bull Gear
By YarrD in forum THE HERCUS AREAReplies: 9Last Post: 23rd January 2010, 08:17 PM -
Gear tooth count on Back/Bull Gear.
By pipeclay in forum THE HERCUS AREAReplies: 31Last Post: 6th January 2010, 11:56 AM -
Bull Gear Info From F.W. Hercus
By steran50 in forum THE HERCUS AREAReplies: 2Last Post: 9th December 2009, 03:00 AM