Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Shipman 520 travel stop pawl
-
15th October 2022, 07:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,434
Shipman 520 travel stop pawl
I have a Jones and Shipman 520 and I was approached by a new member who had seen my posts on it asking for some dimensions for a part. My better half and I have been caught up in the Optus thing, so we are a little wary about sending things to unknown emails at the moment.
Instead, I'll post some drawings and photos here.
The pawl flicks into a groove on the feed wheel; there is a two position ball detent that holds it. The photo shows the out position. In the in position, the end engages with a stop in the groove on the wheel
DSCN9008.JPG
The ball is 3/16" diameter, the spring is 3/8" long, 5/32" OD and is 5 turns of 0.020" wire. Nothing critical there - it just holds the ball in a dimple on the body casting.
DSCN9013.JPG DSCN9011.JPG DSCN9010.JPG
The two most complex parts are the shoulder screw and pawl, drawn below.
Grinder pawl.jpg
Michael
Attached Images
- Grinder pawl.jpg (58.5 KB)
- DSCN9013.JPG (60.8 KB)
- DSCN9011.JPG (54.6 KB)
- DSCN9010.JPG (58.6 KB)
- DSCN9008.JPG (114.2 KB)
Read the full thread at metalworkforums.com...
-
15th October 2022 07:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
A great fix Standard Splitter and Pawl on 10"/12" Tablesaw
By McJag in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 3rd May 2021, 06:44 PM -
Jones and Shipman pics for Bob (Krisfarm)
By Steamwhisperer in forum METALWORK FORUMReplies: 54Last Post: 9th February 2015, 02:29 PM