Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Torture Boards
-
30th August 2006, 09:33 PM #1Member
- Join Date
- Jul 2006
- Location
- Vite Vite, SW Victoria
- Posts
- 93
Torture Boards
Hi All
I will be giving 'Got Wood' a couple of coats of two pack epoxy primer in the next few days or so. After that will be rubbing it back to expose low spots in the plywood where the frames have been pushed in I don't think it will be anything drastic, but just to give it that nice fair finish. The torture board sketched in my plan set is 1800mm long, 80mm wide and 10mm thick, is this the way to go? what should I make it from? In the sketch it has the sandpaper sheets put on along the board with a gap in between, so you end up with 4 - 5 pieces on the board over its length, any comments on that? Any help greatly appreciated.
Regards
Matt Harper
Taipan 4.9
AUS 329
'Got Wood'
-
30th August 2006 09:33 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
30th August 2006, 10:14 PM #2
long board?
I am going to persume you are talking about a long board, torture board is a good name for it though!
There are a few things that vary the type of board that need to use.
The size of the boat and the tightness of the curves in her, it isnt anygood having a really long board if it wont bend around the curves of the boat.
I went with what the Gougeon Brothers recommendation.
About 1100-1200mm long and about 8-10mm thick. The width was dictated by the sand paper I could get which was about 125mm.
It is most important that you use 40 or 60 grit paper and buy a fair bit and replace it often to keep it sharp.
The handles on the board should be about 100mm from the ends. I used curtin rail for these and got them in the right spot for my hands by cutting angles on the ends that fasten to the board and then one screw and an epoxy fillet around them. It is important that they are a single fix point or it may stop the board from flexing.
I fixed the sand paper on by turning over the end and then just using some short staples to fix it.
A fiber glass sail batten and a lead light are needed to check it is fair.
The most important thing is to have a good time, its a character building job!
Scotty
P.S if you want a picture of mine let me know
Similar Threads
-
Jigs for thicknessing narrow boards
By mat in forum HAND TOOLS - POWEREDReplies: 3Last Post: 21st July 2006, 04:21 PM -
Making skirting boards
By Redback in forum ROUTING FORUMReplies: 15Last Post: 17th February 2005, 07:46 PM -
Best Way to Edge-Join Boards?
By SeanS in forum WOODWORK - GENERALReplies: 14Last Post: 12th May 2004, 08:50 AM