Thread: To "wet" or not to "wet"

Hi
Do all the restoration work and then BEFORE you take it to the water, put the hose on the inside and allow it to dribble until the boat holds water.

Won't say who to a clinker for a run after it had been well dried out and only just made it back to shore.

Bert
Another approach, as filling it right up with water might stress the hull too much, hang wet hessian bags all over and keep wet for a few days. Launch and stay close to shore until you're sure she's not going to sink. On the (large) timber boats I've worked on they've used hessian right around the hull and sprinklers to stop the hull drying out for the week of refit.

Mick

Hi Bert,

Notwithstanding anything said above - all good advice - when you are refurbishing make sure you tighten any rivets and roves because they will be well cemented in the dried out timber and may in fact inhibit the timber taking up and sealing where they are. My old man used to get me on the outside to hold against the head while he tightened em on our old clinker bay boat down at Rosebud many years ago.

Jamie

I'd like to thank all the people that replied to my question, it's the first time i've used the "forum" and its a pleasure to talk to people who share the same passion as myself. Thanks, Bert w.