Thanks Thanks:  0
Likes Likes:  0
Needs Pictures Needs Pictures:  0
Picture(s) thanks Picture(s) thanks:  0
Results 1 to 2 of 2
  1. #1
    Join Date
    Jun 2023
    Location
    Croatia
    Age
    38
    Posts
    1

    Default Wooden plank floor on thick joists noise reduction

    Hello guys. Could you please advise me?

    This it the gallery of my house. The wooden joists are 6x4 inches (10x16 cm). I leveled them good.
    I would like to install almost 2 inch thick pine/fir wooden planks on it. I would like to minimize vibrations and squeaking on the floor so I thought I could lay 2 mm rubber on the joists (⁵/₆₄ of an inch) and lay the planks on that but not to screw them on to the joists. I would take additional 2x4 (coloured red) and connect the planks with those and everything would float on the joists. Is this a good idea or should I just screw the planks on the joists? or should I use cork rather than rubber?

    I hope I am being clear, not a native English speaker.

    Every advice is very useful. thank you



  2. # ADS
    Google Adsense Advertisement
    Join Date
    Always
    Location
    Advertising world
    Age
    2010
    Posts
    Many





     
  3. #2
    Join Date
    Nov 2017
    Location
    Melbourne
    Age
    73
    Posts
    358

    Default

    I think you might create a new problem in solving the old one. Rubber compresses, so you might find that the edges of the planks depress and rub against each other and squeak when people walk on them. Depending on what rubber you use, it will probably degrade over time and maybe worsen the squeak. Cork is a natural material, but the same probably applies to it to a greater or lesser extent. You might be better off screwing the planks onto the joists, but if the space under the joists in your picture stays open you might be better off in the long term screwing timber or angle iron to your joists and pulling the planks down onto the timber or angle iron from below through the timber or angle iron. It's the same way that some problem noisy floorboards are dealt with in established houses. This also gives you a clear surface on the planks in your room and the ability to tighten the screws from below if there is movement.

Similar Threads

  1. Noise Reduction
    By MWF FEED in forum METALWORK FORUM
    Replies: 0
    Last Post: 7th May 2020, 10:20 AM
  2. Noise Reduction - CV1800
    By Chris Parks in forum DUST EXTRACTION
    Replies: 38
    Last Post: 6th July 2016, 11:11 AM
  3. Noise Reduction
    By Chris Parks in forum DUST EXTRACTION
    Replies: 8
    Last Post: 20th November 2011, 07:47 PM
  4. noise reduction
    By robyn2839 in forum WOODWORK - GENERAL
    Replies: 4
    Last Post: 25th June 2011, 04:26 PM
  5. Noise reduction
    By RichI in forum WOODWORK - GENERAL
    Replies: 10
    Last Post: 19th March 2008, 08:36 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •