Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Refectory Table
-
21st April 2003, 11:05 AM #1Senior Member
- Join Date
- Jul 2002
- Location
- Donvale, Vic
- Posts
- 148
Refectory Table
Would like to show you some of my work, and would appreciate any feed-back / suggestions.
Just completed the second of these, and am about to start the third, to be made with two complementary benches.
The first two were 2400 x 1080. the next is to be 2100 x 1080.
They are made from re-cycled 70 yr old Tas. Oak, 30mm thick. The timber came from floorboards at the old Kinnear's Rope Works. The table is skip-dressed, French polished, and waxed.
The photo was taken with a flash, and makes the colour more red, than it actually is.
Mick4412Last edited by Mick4412; 21st April 2003 at 11:14 AM.
-
21st April 2003 11:05 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
23rd April 2003, 10:00 AM #2
Feedback = wow
Questions = what did you use for the thick frame pieces? and what is skip dressed?
Looks excellentGreat minds discuss ideas,
average minds discuss events,
small minds discuss people
-
23rd April 2003, 07:37 PM #3Senior Member
- Join Date
- Jul 2002
- Location
- Donvale, Vic
- Posts
- 148
Dave,
The vertical timber is 4 of the 135 x 30 boards, laminated 2x2.
The "feet" are 2 boards laminated, as is the spreader or rat-rail.
"Skip-dressing " is leaving in the timber all of the original distress marks. The piece was belt-sanded to remove dirt etc, taking care not to remove the "nice" character, then further sanded with an orbital sander in preparation for the French Polishing.
Thanks for your feed back
Regards
Mick
-
26th April 2003, 09:26 PM #4Senior Member
- Join Date
- Jul 2002
- Location
- Donvale, Vic
- Posts
- 148
Reply to Doorstop
Hmmmm Woooodporn.
Bit too cryptic for me
Doorstop
Tell me what you really think, in language I will understand
Thanks
mick
-
26th April 2003, 11:58 PM #5Banned
- Join Date
- Mar 2003
- Location
- x
- Posts
- 590
Very nice work. I can't tell from the photo, did you use a through tenon on the spreader ?
-
27th April 2003, 10:27 AM #6Senior Member
- Join Date
- Jul 2002
- Location
- Donvale, Vic
- Posts
- 148
Thanks Doorstop
Ken
4 x 12.5 mm dowel each end, thro' vertical boards and then 75mm into spreader. Makes sure the bugger won't move !
mick
-
27th April 2003, 10:46 PM #7
Verrrry nice! Nice proportions, nice practical look, nice finish & well photographed.