Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Push or Pull
-
16th March 2013, 01:37 PM #1GOLD MEMBER
- Join Date
- Aug 2005
- Location
- Queensland
- Posts
- 2,947
Push or Pull
Ever read the instructions for the application of sealants in cartridges?
Every one I have read says to push the sealant ahead of the cartridge - I understand to logic of this as it says it will push the sealant into the groove etc. I have tried it a number of times without success - it ends up as a hell of a mess of wasted sealant clinging to the nozzle and plastered over any masking tape used as defining edges. I tend to pull the cartridge with the nozzle forced against the groove and finish up by running a silicone tool or suitable sized piece of curved poly irrigation pipe [dipped in the appropriate solvent] to force it into the groove and to finish the surface.
Never seen a tradie or anyone use the push method.
Anyone use it successfully?
-
16th March 2013 01:37 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th March 2013, 02:04 PM #2
I pull it, but only because I've never read the instructions! Though I can see what you are saying in relation to the push method.
-
16th March 2013, 02:22 PM #3
Nope. I cut the nozzle on about a 45° angle, put the angle almost flat against the surface and pull. That's how all the tradies I know do it, too.
- Andy Mc
Similar Threads
-
Push or pull on ally using MIG?
By constablechris in forum WELDINGReplies: 5Last Post: 2nd January 2012, 10:17 PM -
Difference in Push/Pull with MIG
By DirtPig in forum WELDINGReplies: 4Last Post: 28th September 2011, 09:09 PM -
Wire in a push pull gun...
By constablechris in forum METALWORK FORUMReplies: 17Last Post: 24th September 2011, 11:18 AM -
Do You Push A CSM OR Pull it?
By echnidna in forum SMALL TIMBER MILLINGReplies: 17Last Post: 16th February 2008, 08:41 AM -
Push or Pull the router
By Template Tom in forum POLLSReplies: 26Last Post: 24th January 2005, 05:20 PM