Thread: Roof racks for a Toyota hilux may 97 model.

Go with DJ's design.

Yours would not comply in Vic and more than that, would be a vision obstruction. Keep the pipes as close in to the body as possible.

Don't weld anything while attached to the car. You will probably fry your electronics.....

Dan

Ta Dan, if it won't comply I definetly won't do it.

Bit confused on how it'll obscure vision significantly though. The upright closest from the drivers seat is hiding behind the right strut (if thats what its called) to the roof.

For welding, I was intending to unhook the battery. Would have thought that be enough. But I'm no expert so wont do it. Shame though.

Had a look under the car today. Still not sure which existing holes I should fasten the uprights too...anyway.

DJ's pic is pretty much what I was talking about. You could double the top side rails and weld some zig-zag rod between them to make the rack more rigid, so you can extend it further forward/backwards from the uprights - just be wary of loading it heavily at the ends as the overhang will increase the force on the chassis connections due to leverage.

I think you should be able to get a third set of 'legs' at the side between the rear wheel arch and the tail lights, so it should not interfere with the tailgate operation and a 'tonneau' should be able to be slid off if it is one of those new rigid plastic/fiberglass lockdown ones.

Also, good call about frying the electrics - most of the cars I have worked on didn't have anything more complicated than a clock.

Thanks mate. Appreciate the help.