Thread: Cross cut sled for Bosch GTS 10 XC

investigate UHMW polyethylene runners from Carbatec -- the stuff can be trimmed with your saw

or timber runners

I've never seen anything that you can buy off the shelf to fit non-standard mitre slots. So, as others have said, you'll have to cut your own.

Originally Posted by ian

investigate UHMW polyethylene runners from Carbatec -- the stuff can be trimmed with your saw

should have included this link UHMW Length - 1/2" x 4" x 24" (12.7 x 100 x 610mm) | Workshop Hardware & Fittings - Carbatec

The UHMW plastic is also available as pre-cut strips ready to insert into your mitre slot. Cost about $10 each.
If you mount the strips so that they are located towards the edge of the slot closest to the saw blade, an fit matching the width of the slot is not required.

Thanks will pop into carbatec tomorrow and give it a go as paste wax was another nightmare trying to find today in three different stores

Another option is Microjig's zero play bars.

Microjig Zero Play Mitre Bar Kit | Carbatec

Depending on the size of your sled these may work well for your situation. I find them a little bit small for my liking, so i use them for sleds that don't get a lot of use.

Originally Posted by tonzeyd

Another option is Microjig's zero play bars.

The OP's saw doesn't have standard 3/4" by 3/8" mitre slots so no standard hardware fits.