Thanks: 0
Likes: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: table saw aligning modification
-
15th July 2008, 10:24 PM #1Member
- Join Date
- Nov 2005
- Location
- Adelaide South Australia
- Posts
- 72
table saw aligning modification
Hi All. I thought I would share my method of aligning the table of my TSC10B. This mod allows you to microadjust the table position relative to the blade using a large barrell screw. This avoids the rubber mallet or block of wood and hammer method of "microadjusting". Set up the barrell screw with as little slop as possible in the bolt to bracket connection for best results. Picture explains the set up.
how do I join up the shavings?
-
15th July 2008 10:24 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th July 2008, 12:36 AM #2SENIOR MEMBER
- Join Date
- Sep 2007
- Location
- Nicholls ACT
- Posts
- 728
Looks good. I have always wondered when people talk about accuracies in the order of a few thou and adjusting with a mallet. Thanks for sharing.
I never make mistakes, I thought I did once but I was mistaken
Top 10 reasons I procrastinate
1......
-
17th July 2008, 06:46 AM #3Deceased
- Join Date
- Jan 2006
- Location
- poland
- Age
- 78
- Posts
- 761
That's a grate idea...very well done and I'm sure that you can adjust the blade to even to ±0.
I have an EB PK-255 and the blade alignment is done by tightening nuts on each side of the casing....otherwise, I would use your idea.
Excellent
Regards
niki
-
17th July 2008, 09:50 AM #4Member
- Join Date
- Nov 2005
- Location
- Adelaide South Australia
- Posts
- 72
Thanks Niki It does give you that accuracy and is very easy to use. Very cheap and not difficult to install. Hazard
how do I join up the shavings?
Similar Threads
-
Router Table modification
By Stuart in forum TRITON / GMCReplies: 28Last Post: 23rd July 2005, 10:04 PM -
Problem aligning saw
By Mad Mat in forum TRITON / GMCReplies: 4Last Post: 8th February 2005, 06:39 AM -
Aligning saw - no more slot space to move saw locator
By Chipmunk in forum TRITON / GMCReplies: 7Last Post: 26th October 2004, 06:04 PM -
Tired of Re-Aligning Work Centre
By Markw in forum TRITON / GMCReplies: 59Last Post: 23rd October 2004, 01:27 PM -
Aligning the workcentre (#@&$#$@#@)
By AVermeylen in forum TRITON / GMCReplies: 52Last Post: 4th May 2004, 02:11 PM