Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
6th August 2005, 04:19 AM #1Awaiting Email Confirmation
- Join Date
- Aug 2005
- Location
- Western Australia
- Posts
- 11
High Figured Blackwood on the 1/4
Hi, I am looking for some highly figured Blackwood that has been sawn right on the quarter. The board size I am after must be min 225 (250 is better) x 25 (50 is better) x 1500.
It is important that it be 1/4 sawn as I intend to resaw into back and side sets for acoustic guitars I am building for my family.
Any help would be greatly appreciated.
Regards
Kim
-
6th August 2005 04:19 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
6th August 2005, 10:31 AM #2
Have sent you an Email with a contact in W A
p.t.c
-
6th August 2005, 12:38 PM #3Awaiting Email Confirmation
- Join Date
- Aug 2005
- Location
- Western Australia
- Posts
- 11
Thanks PTC, much apreciated.
-
10th August 2005, 02:29 AM #4Originally Posted by larkim
Quarter sawn stock always good if you can get it but for backs and sides it's not as critical as for a top. I dont know youre experience so if you already know this then ignore the rest of my post.
Unless youre dead set on going quarter sawn you may find near quarter sawn will do just as good a job. Might be a bit cheaper too.
Throw up some pics of the instruments on the forum when you finish for all to see.
Cheers MartinWhatever note you blow youre never more than a semitone away from the correct one....(Miles Davis)
-
10th August 2005, 02:37 AM #5Originally Posted by ptc
Thanks MartinWhatever note you blow youre never more than a semitone away from the correct one....(Miles Davis)
Similar Threads
-
High Chair Plans
By Mick4412 in forum DESIGNS & PLANS FOR PROJECTSReplies: 5Last Post: 17th September 2005, 08:28 PM -
Blackwood / Qmaple
By VEEBULL in forum TIMBERReplies: 10Last Post: 7th April 2005, 09:56 PM -
Blackwood and Celery Top pine...SALE.
By Tasman in forum TIMBERReplies: 6Last Post: 2nd April 2005, 02:43 AM -
Blackwood Table restoration
By Gumby in forum FINISHINGReplies: 6Last Post: 28th October 2003, 01:18 PM -
Rail & Stile bits - 1/4" router
By AshleyM in forum ROUTING FORUMReplies: 4Last Post: 25th November 2002, 10:38 PM