Thread: How to sand

Belt sanders work a treat.

I used to determine the minimum radious I could sand in and cut my boxes no less than that radious. Glue abrasive to dowel and sand on the lathe.

Almost forgot. Rounding over bit in the old router.Hope that helps?

I reckon ya put the sand paper in the corner of the room and run the piece back and forth. Practice, router, hand plane, or a sandpaper block.

I love deadlines. I love the sound of them going by.

Its smart to sand the bits before you put it together with glue. Then youshould only have to cleanup sand a little bit.

Sand to a point. If you are making face frames you do not want to round the corners. You do not want to round the ednges of shelves if you are going to apply a wood or plastic strip to the edge. I use Forest blades at $120 USD. They leave no saw marks The blades cost a lot but you more than make up for it in saved time. It does not leave it to slick which makes it hard to glue up. You can mix the saw dust with carpenters glue and make a good filler to match if you need it. They make a foam rubber pad to hold your work so it does not go flying while sanding or routing. I have used rubber carpet pad for 30 years for this purpose. Richard

I've been using the Fein for edges.