Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
-
5th August 2014, 11:38 PM #16
SENIOR MEMBER
- Join Date
- Aug 2011
- Location
- victoria
- Posts
- 524
I have think about it but the job is only 8mm dia brass and only 18mm long , if i leave the bar long to cut with the slitting saw then it will flex bad i think .
Originally Posted by bollie7
Peter
-
5th August 2014 11:38 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
6th August 2014, 07:51 AM #17
Philomath in training
- Join Date
- Oct 2011
- Location
- Adelaide
- Age
- 59
- Posts
- 3,149
If you sandwich the brass between the cutter and an angle block it should not flex away. I have (as probably do many others) a 1mm slitting saw that would do the job. If it is only one piece of brass 8mm diameter, 18mm long with a 6mm deep 1mm wide slot down the length I could even do it for you.
Michael
-
6th August 2014, 10:57 AM #18
SENIOR MEMBER
- Join Date
- Aug 2011
- Location
- victoria
- Posts
- 524
Hi Michael. Originally Posted by Michael G
Thanks for your suggestion . i will try it . if i fail then i might take up your offer
regards
peter
Similar Threads
-
endmill sharpening
By eskimo in forum METALWORK FORUMReplies: 17Last Post: 4th August 2013, 10:59 PM -
Useful endmill rpm chart
By morrisman in forum METALWORK FORUMReplies: 14Last Post: 6th October 2011, 10:29 PM -
$530 endmill
By Greg Q in forum METALWORK FORUMReplies: 9Last Post: 24th June 2011, 09:19 PM
