Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: 6x26 mill questions
-
25th June 2019, 02:40 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,402
6x26 mill questions
Good evening collective wisdom...
I have a "toptech" 6x26 mill. (same factory as optimum)
I want to install a tacho on the spindle, but not sure exactly where it could fit.
This is a photo of the top of the spindle.
Firstly, I noticed today that there are 2 notches in the lock ring (?), and 2 screws which look like they maybe should be in the notches, but aren't....
Can anyone confirm? If so, should I loosen the ring to align, or tighten?
I wondered if I could make an aluminium bracket attached via one of those screws to hold the hall effect sensor magnet past the belt? I'm assuming I would need to make one for each side to keep whatever balance there is.
(the black and white pattern was an earlier attempt, using an optical sensor ex printer with a frequency meter - 60 pulses per rev results in the frequency being rpm. It wasnt 100% successful)
Russ
Read the full thread at metalworkforums.com...
-
25th June 2019 02:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
6x26 mill questions
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 22nd June 2019, 10:50 PM -
VFD ON MILL QUESTIONS
By iron bark in forum METALWORK FORUMReplies: 5Last Post: 8th April 2014, 09:40 PM -
Herlss Mill questions
By Stustoys in forum METALWORK FORUMReplies: 66Last Post: 27th August 2010, 03:12 PM -
End mill questions.
By JDarvall in forum GENERAL & SMALL MACHINERYReplies: 8Last Post: 17th November 2007, 06:29 AM