Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Abnox Wanner Oiler Bits
-
22nd June 2015, 10:05 AM #1Senior Member
- Join Date
- Mar 2009
- Location
- Melbourne
- Age
- 54
- Posts
- 380
Abnox Wanner Oiler Bits
In another thread Anorak Bob as asked if I could take a few photos of the innards of an Abnox Wanner oil gun I use, I figured I'd start a new thread rather than hijack the original and this might be of some use to others.
First photo shows the oiler pretty much disassembled and all of the major components
Abnox Wanner 01.jpg
Second photo is a view of where the pump housing screws onto the main oil cylinder including the sealing washer (left) and the opposite end of the pump housing where the pump cylinder comes out including the o-ring (right)
Abnox Wanner 02.jpg
Last is a photo of the oiler freshly refiled and ready to close up.
Abnox Wanner 03.jpg
Hope this is useful.
Cheers,
Greg.
-
22nd June 2015 10:05 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
22nd June 2015, 01:08 PM #2.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
Thank you Greg for going to the trouble of dismantling your perfectly good oiler and for the photos.
Wanner has revised the design. My two are filled via the end cap, the seal in one being a cause of considerable leakage. Oil also leaks from the outer telescoping pump housing. I might investigate the availability of spare parts. The age of mine may not be in their favour though. Still, they work, just messily.
Bob.
115 (Large).jpg
Similar Threads
-
Oiler Plans
By morrisman in forum METALWORK FORUMReplies: 10Last Post: 28th March 2015, 11:50 AM -
Wanner Pump Oiler Refurbishment
By Anorak Bob in forum METALWORK FORUMReplies: 10Last Post: 14th October 2012, 07:15 AM -
problem chainsaw oiler??
By timbertalk in forum SMALL TIMBER MILLINGReplies: 4Last Post: 11th April 2009, 08:08 PM -
aux oiler
By weisyboy in forum SMALL TIMBER MILLINGReplies: 12Last Post: 1st December 2007, 09:26 AM