Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
21st October 2021, 08:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,403
Accurate collet chuck reducer ring needed
Just exploring options at the moment. I may need reduce the register of a collet chuck from 43mm x 7mm to 22mm x 7mm. So a ring 43mm x 7mm and a bore of 22mm is needed. Any suggestions on how to achieve this? Would the best way be to get a piece of hollow bar and machine the face, OD and bore the centre without disturbing setup and then part off to length. Should be pretty accurate I am guessing. It's so I can adapt this collet chuck to a Toyo ML-1.
Part number 050-110-25600 at this link -
050-110-25600
Mount holes will need to be redone to a 35mm PCD to suit the spindle, as the spindle is 40mm diameter, but that's fairly easy if there's enough clearance when collet nut is removed.
Read the full thread at metalworkforums.com...
-
21st October 2021 08:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Chuck has a ring
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 7th December 2019, 10:50 PM -
Collet chuck
By Fumbler in forum WOODTURNING - PEN TURNINGReplies: 8Last Post: 18th March 2017, 09:50 AM -
Slot alignment - collet reducer
By mat in forum ROUTING FORUMReplies: 3Last Post: 11th May 2015, 07:04 PM -
New Box for my Collet Chuck/Set
By dai sensei in forum WOODTURNING - GENERALReplies: 10Last Post: 30th October 2011, 08:46 PM