Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 33 of 33
Thread: ACME 1/2 - 8 LH rod available ?
-
30th November 2011, 10:22 PM #31Dave J Guest
Hi Mike,
Do you have a welder to make one up? If not you could bolt one together out of steel.
I picked up a spare fixed and traveling steady for my Chinese lathe and am going to make them both into roller steadies when I get around to it. A couple of skate type bearings will do the job.
Pipeclay had the roller fingers in the for sale section and I think they are also on that Hercus spares website from Sydney to see a picture of them. They would be easy enough to make up.
Dave
-
30th November 2011 10:22 PM # ADSGoogle Adsense Advertisement
-
1st December 2011, 06:00 AM #32GOLD MEMBER
- Join Date
- Jun 2007
- Location
- sydney
- Age
- 64
- Posts
- 3,566
-
1st December 2011, 10:22 AM #33
rod
Ok thanks for the replies . I have been informed that ENCO in the USA sell the stuff. But it isn't cheap . With postage, a 6 feet length will be around $80 I think. Making up a follow rest ..yes, I spotted steamwhisper's idea of a plate with a bush in it - might be the quick answer . I did get a follow rest with my other lathe , but its too large , the centre height is too high , but I may be able to rig up something using it for a one off job . Mike
Similar Threads
-
ACME Threaded rod
By Lyle in forum METALWORK FORUMReplies: 2Last Post: 2nd June 2011, 06:06 PM -
Where to get ACME antibaclash nuts?
By pkowal in forum CNC MachinesReplies: 5Last Post: 6th June 2010, 01:24 PM -
Couplers - Stepper to Acme
By Blu_Rock in forum CNC MachinesReplies: 9Last Post: 27th September 2008, 09:59 PM -
Local source for ACME screws
By snowyskiesau in forum CNC MachinesReplies: 10Last Post: 22nd August 2008, 03:21 AM -
7/16" ACME LH 10 TPI Tap
By garf in forum METALWORK FORUMReplies: 4Last Post: 7th December 2005, 08:14 PM